Advertisement
Additional Operation
Before you install this unit's control box on the printer, carry out
the following additional operation. This operation uses the ex-
tension plate to change the position where the AC adapter is
mounted.
This operation also requires a Phillips screwdriver (not included)
for tightening the screws.
1
Detach the AC adapter from the control box.
AC adapter
2
Attach the extension plate to the control box.
The extension plate has a front and a back. Orient the ex-
tension plate so that the screw holes are positioned as shown
in the figure.
To attach the extension plate, use the included screws and
the small cap screw.
Extension plate
Small cap screw
(included item)
Screws
(included items)
Control box
3
Attach the AC adapter.
To attach it, use the screws and cap screw you removed in
step 1.
Note that the AC adapter is installed at a location opposite
its original position.
4
This completes the additional operation. Continue by
following the instructions in the user's manual to in-
stall the unit.
Copyright© 2003 Roland DG Corporation
http://www.rolanddg.com/
Cap screw
(removed in step 1)
Screws
(removed in step 1)
R1-030312
Advertisement
