Table of Contents
Advertisement
Releasing the Electric
Brake
You can manually release the electric brake by
rotating the link arms forward. Once the electric brake
is energized, the brake resets.
1.
Turn the key to the
the battery.
2.
Locate the shaft on the electric brake where the
brake link arms are connected
3.
Rotate the shaft forward to release the brake.
Figure 44
1. Brake-link arm on the electric brake control module
2. Left, rear tire
position or disconnect
OFF
(Figure
44).
Belt Maintenance
Inspecting the Belts
Service Interval: Every 25 hours—Check the belts
Replace the belt if it is worn. The signs of a worn belt
include squealing while the belt is rotating; the blades
slipping while cutting grass; and frayed edges, burn
marks, and cracks on the belt.
Replacing the Mower Belt
The signs of a worn belt include squealing while the
belt is rotating, blades slipping while cutting grass,
and frayed edges, burn marks, and cracks on the belt.
Replace the mower belt if any of these conditions are
evident.
1.
Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Set the height of cut at the lowest cutting position
g027911
(38 mm (1-1/2 inches).
4.
For machines with a 107 cm (42-inch) deck,
remove the pulley covers
1. Cover
5.
Using a spring-removal tool (Toro Part No.
92-5771), remove the idler spring from the deck
hook to remove tension on the idler pulley, and
roll the belt off the pulleys
47).
WARNING
The spring is under tension when
installed and can cause personal injury.
Be careful when removing the belt.
41
for wear or cracks.
(Figure
Figure 45
Mower deck with 2 blades
2. Screw
(Figure 46
45).
g032555
and
Figure
Hide quick links:
Advertisement
Table of Contents
