Toro TimeCutter SS3225 Operator's Manual page 47

4. Carefully rotate the blade(s) so they are facing
front to rear (Figure 60
Figure 60
Mower Decks with 1 Blade
1. Blade front to rear
2. Measure from the tip of the blade to the flat surface here.
Figure 61
Mower Decks with 2 Blades
1. Blades front to rear
2. Measure from the tip of the blade to the flat surface here.
5. Measure from the tip of the front blade to the flat
surface, and the tip of the rear blade to the flat
surface (Figure 60
Note:
If the front blade tip is not 1.6 to 7.9 mm
(1/16 to 5/16 inch) lower than the rear blade tip,
adjust the front locknut.
6. To adjust the front-to-rear blade slope, rotate the
adjustment nut in the front of the mower
62).
and Figure 61).
and Figure 61).
(Figure
g014631
1. Adjusting rod
2. Adjusting block
7. To raise the front of the mower, tighten the
adjustment nut.
8. To lower the front of the mower, loosen the
adjustment nut.
9. After adjustment, check the front-to-rear slope
again, continue adjusting the nut until the front
blade tip is 1.6 to 7.9 mm (1/16 to 5/16 inch)
lower than the rear blade tip
Figure 61).
10. When the front-to-rear blade slope is correct,
check the side-to-side level of the mower again;
g009658
refer to Leveling from Side to Side (page
47
Figure 62
3. Locknut
(Figure 60
g014634
and
45).