Removing The Mower Deck - Toro TimeCutter SS 4225 Operator's Manual

1. Adjusting rod
2. Adjusting block
7. To raise the front of the mower, tighten the
adjustment nut.
8. To lower the front of the mower, loosen the
adjustment nut.
9. After adjustment, check the front-to-rear slope
again, continue adjusting the nut until the front
blade tip is 1.6 to 7.9 mm (1/16 to 5/16 inch)
lower than the rear blade tip
10. When the front-to-rear blade slope is correct,
check the side-to-side level of the mower again;
refer to Leveling from Side to Side (page

Removing the Mower Deck

1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Lower the height-of-cut lever to the lowest
position.
4. Remove the hairpin cotter from the front support
rod, and remove the rod from the deck bracket
(Figure 58).
Figure 57
3. Locknut
(Figure 56).
g014634
1. Front support rod
2. Locking nut
5. Carefully lower the front of the mower deck to
the ground.
6. Lift the mower deck and hanger brackets clear
of the rear lift rod and lower the mower carefully
to the ground
44).
1. Mower deck
2. Hanger bracket
7. Slide the mower deck rearward to remove the
mower belt from the engine pulley.
46
Figure 58
3. Deck bracket
(Figure 59).
Figure 59
3. Rear lift rod
g014635
g005077