Storing The Battery - Toro TimeCutter SS 4225 Operator's Manual

an alcohol-based stabilizer (ethanol or
methanol).
Note:
A fuel stabilizer/conditioner is most
effective when mixed with fresh fuel and
used at all times.
B. Run the engine to distribute conditioned fuel
through the fuel system (5 minutes).
C. Shut off the engine, allow it to cool, and
drain the fuel tank.
D. Start the engine and run it until it stops.
E. Dispose of fuel properly. Recycle the fuel
according to local codes.
Important:
stabilizer/conditioned fuel over
90 days.
13. Remove and check the condition of the spark
plug(s); refer to Servicing the Spark Plug (page
36). With the spark plug(s) removed from the
engine, pour 30 ml (2 tablespoons) of engine
oil into the spark plug hole. Use the starter to
crank the engine and distribute the oil inside the
cylinder. Install the spark plug(s). Do not install
the wire on the spark plug(s).
14. Check and tighten all bolts, nuts, and screws.
Repair or replace any part that is damaged.
15. Paint all scratched or bare metal surfaces. Paint
is available from your Authorized Service Dealer.
16. Store the machine in a clean, dry garage or
storage area. Remove the key from the switch
and keep it out of reach of children or other
unauthorized users. Cover the machine to
protect it and keep it clean.
Do not store

Storing the Battery

1. Fully charge the battery.
2. Let the battery rest for 24 hours, then check the
battery voltage.
Note:
If the battery voltage is below 12.6 V,
repeat steps 1
3. Disconnect the cables from the battery.
4. Check the voltage periodically to ensure that the
voltage is 12.4 V or higher.
Note:
If the battery voltage is below 12.4 V,
repeat steps 1
Battery Storage Tips
•
Store the battery in a cool, dry area in an upright
position.
•
Do not stack batteries directly on top of each other,
unless they are in cartons.
•
Do not stack more than 3 batteries (only 2 if the
battery type is commercial).
•
Test a wet battery every 4 to 6 months and charge
it, if necessary.
•
Always test and charge the battery before
installation.
50
and 2.
and 2.