Drive System Maintenance; Checking The Tire Pressure; Releasing The Electric Brake - Toro TimeCutter SS 4225 Operator's Manual

Drive System
Maintenance

Checking the Tire Pressure

Service Interval: Every 25 hours—Check tire
pressure.
Maintain the air pressure in the front and rear tires as
specified. Uneven tire pressure can cause an uneven
cut. Check the pressure at the valve stem
Check the tires when they are cold to get the most
accurate pressure reading.
Refer to the maximum pressure suggested by the tire
manufacturer on the sidewall of the caster wheel tires.
Inflate the rear drive-wheel tires to 90 kPa (13 psi).
Figure 42
1. Valve stem
Releasing the Electric
Brake
You can manually release the electric brake by
rotating the link arms forward. Once the electric brake
is energized, the brake resets.
1. Turn the key to the
the battery.
2. Locate the shaft on the electric brake where the
brake link arms are connected
(Figure 42).
3. Rotate the shaft forward to release the brake.
g000554
1. Brake-link arm on the electric brake control module
2. Left, rear tire
40
position or disconnect
OFF
(Figure 43).
Figure 43
g027911