Toro TimeCutter SS 4225 Operator's Manual page 10

Note:
This machine complies with the industry standard stability test in the static lateral and longitudinal tests with the maximum
recommended slope indicated on the decal. Review the instructions for operating the machine on slopes in the Operator's Manual as
well as the conditions in which you would operate the machine to determine whether you can operate the machine in the conditions
on that day and at that site. Changes in the terrain can result in a change in slope operation for the machine. If possible, keep the
cutting units lowered to the ground while operating the machine on slopes. Raising the cutting units while operating on slopes can
cause the machine to become unstable.
1. Warning—read the
Operator's Manual.
2. Warning—before
performing maintenance,
read the Operator's Manual;
engage the parking brake,
remove the key, and
disconnect the spark plug.
3. Cutting/dismemberment
hazard of the hand, mower
blade; entanglement
hazard of the hand,
belt—stay away from
moving parts; keep all
guards and shields in place.
4. Thrown object
hazard—keep bystanders
away; pick up debris
before operating; lower the
deflector before using the
machine.
132-0869
5. Ramp hazard—do not
use dual ramps when
loading onto a trailer; use
1 ramp wide enough for
the machine; use a ramp
with a slope less than 15°;
back up the ramp when
loading the machine and
drive forward off the ramp
when unloading.
6. Runover/backover
hazard—do not carry
passengers; look behind
you when mowing in
reverse.
10
decal132-0869
7. Tipping hazard—do not
use on slopes near open
water; do not use on slopes
greater than 15°.