Using The Side Discharge; Adjusting The Height Of Cut - Toro TimeCutter SS 4225 Operator's Manual

Using the Side Discharge

The mower has a hinged grass deflector that
disperses clippings to the side and down toward the
turf.
DANGER
Without a grass deflector, discharge cover, or
a complete grass-catcher assembly mounted
in place, you and others are exposed to blade
contact and thrown debris. Contact with
rotating mower blade(s) and thrown debris
will cause injury or death.
• Never remove the grass deflector from the
mower deck because the grass deflector
routes material down toward the turf. If the
grass deflector is ever damaged, replace it
immediately.
• Never put your hands or feet under the
mower deck.
• Never try to clear the discharge area
or mower blades unless you move the
blade-control switch (PTO) to the O
position, rotate the key switch to the O
position, and remove the key from the key
switch.
• Make sure that the grass deflector is in the
down position.

Adjusting the Height of Cut

Note:
The transport position is the highest
height-of-cut position or cutting height at 115 mm
(4-1/2 inches) as shown in
Height of cut is controlled by the lever located to the
right of the operating position
FF
FF
24
Figure 21.
(Figure 21).
Figure 21
g028025