Table of Contents
Advertisement
Properly connected leg section with pin fully extended
INCORRECT connection – pin not fully extended
Three of the nine leg sections feature a rounded end. These must always be installed as the lowest
leg sections when the Tripod is erected.
Whenever connecting leg sections the Tripod must first be laid on a horizontal surface. After the
desired number of leg sections is connected carefully stand the Tripod up while simultaneously
spreading the legs out for stability.
WARNING: Always use the same number of legs sections on each of the three legs.
5.2 Lifting Cable and Locking Device
For fine adjustment of drop height, a flexible steel cable is used to raise and lower the steel lifting
block. To prevent the cable position from changing the supplied locking device is attached to the
leg section adjacent to the location where the cable exits the tripod head.
17
Advertisement
Table of Contents
