Triax ASTM F1292 User Manual page 13

Touch wireless surface impact tester
Table of Contents

Advertisement

Pressing LAST or NEXT will allow you to view other drops. Press BACK to go back to previous
menu
3.4 Batteries and Charger
The Triax Touch hand held and missiles each make use of permanent internal rechargeable nickel
metal hydride (NiMH) batteries. Each Triax Touch system is supplied with a battery charger with
technology matched to the NiMH batteries used. The batteries in both the hand held and missile
requiring charging independently.
WARNING: DO NOT USE A BATTERY CHARGER OTHER THAN SUPPLIED WITH
THE TRIAX TOUCH SYSTEM. USING A BATTERY CHARGER OTHER THAN THE
ONE SUPPLIED WITH THE TRIAX SYSTEM COULD RESULT IN BATTERY
DAMAGE, POSSIBLY RESULTING IN FIRE AND PROPERTY DAMAGE.
DO NOT ATTEMPT TO USE THE TRIAX TOUCH WITH THE CHARGER
CONNECTED!
To charge either the head form or hand held plug the charger into the charger receptacle and plug
the charger in AC mains power. The charger runs on either 110VAC or 220VAC power without
adjustment or additional power converters. Initially a small LED on the charger will be green and
then switch to red when the charging begins. Depending on the level of charge left in the battery
up to six hours might be required for a full charge. When fully charged the LED will turn green.
Note that the charger is protected from overcharging the battery and may be left connected after
the LED turns green.
If the charger is unplugged and immediately plugged back in, the LED will once again go from
green to red. After a few minutes the LED will return to green.
12

Advertisement

Table of Contents
loading

Related Products for Triax ASTM F1292

Table of Contents