Auto Mute/Auto Mute Volume; User Speed Limit - Uniden R7 User Manual

the frequency you muted. It will automatically mute when you travel to that location
and the saved frequency is detected; however, if a different frequency is detected,
the R7 alerts to that different frequency.
When you press MUTE/DIM or the MUTE button on the power cord to mute audio
for a specific location, Mute On displays. While Mute On displays, press MUTE/DIM
or the MUTE button on the power cord again to save that GPS location to memory.
Mute Memory displays on the screen.
R7 stores 2000 points divided between Mute Memory and User Mark locations.
To delete Mute Memory points, press MUTE/DIM or the MUTE button on the
power cord while Mute Memory displays. The R7 displays a delete confirmation
message; press MUTE/DIM or the MUTE button on the power cord again to
confirm. You can also delete Mute Memory points from Menus/Delete All Mute?

AUTO MUTE/AUTO MUTE VOLUME

When the R7 detects a signal, it sounds an alarm at the current volume level. To
make the alarm quieter, turn Auto Mute on through the menus (see page 19). This
will reduce the volume to the level set (0 - 7) in the Auto Mute Volume menu (see
page 19).
Regardless of how high Auto Mute may be set, it will never be at a higher level than
the actual volume level. For example, if the volume is set to level 5 and Auto Mute
Volume is set to level 7, Auto Mute will keep the volume at level 5, the same as the
actual volume level.
Auto Mute ends 10 seconds after the alarm ends unless:
• The same signal is detected within that 10 second period; then, Auto Mute stays
on.
• A different band signal is detected during that 10 second period; then, Auto Mute
turns off and then back on at the current volume level.

USER SPEED LIMIT

When you set a speed limit thorough the menus, the R7 sends an alarm tone if your
speed exceeds that speed limit setting. If that happens, the unit announces and
displays over speed warnings.
Auto Mute does not apply to Laser Alert.
- 30 -