Electrical Devices; Starting The Engine - BorMann PRO BGB3000 Manual

EN
CAUTION:
To minimize gum deposits in your fuel system and to insure easy starting, do not use gasoline left over from the previous season.
CAUTION:
Pressure can build up in the fuel tank. Allow the generator to cool for at least two minutes before removing fuel cap. Loosen the fuel
cap slowly to relieve any pressure in the tank.
E. Electrical devices
Disconnect all electrical devices from the generator and switch off the AC circuit breaker before start the engine. The generator may be hard to start
with electrical devices.
F. Grounding
The generator must be properly connected to an appropriate ground. It helps prevent electrical shock if a ground fault condition exists
in the generator or in connected electrical devices, especially when the unit is equipped with a wheel kit. Proper grounding also helps
dissipate static electricity, which often builds up in ungrounded devices.
DANGER of Electrical Shock
A ground terminal on the frame of the generator has been provided on the generator end. For remote grounding, connect a length
of heavy gauge (4 mm2 ) copper wire between the generator ground terminal and a copper rod driven into the ground. The National
Electrical Code requires that the frame and external electrically conductive parts of this generator be properly connected to an ap-
proved earth ground. Local electrical codes may also require proper grounding of theunit. We strongly recommend that you consult
with a qualified electrician for grounding requirements in your area.

2. Starting the engine

1. Perform operating checklist.
2. Turn fuel valve to the "ON" position.
4. Pull the choke valve switch to "CLOSE" position.
CAUTION: Choke plate should be setting in different
width due to temperature and other factors.
8
Failure to properly ground the generator can result in electric schock.
3. Turn off AC breaker protector.
5. Electric start:
Turn and keep the key to "START" position till the en-
gine is started. After the engine is started, release thek-
ey to return to "RUNN position. Manual start: Turn the
switch to "RUN" position. The switch button according
to the open position, and then seize the starter handle
and slow pulling until there is a sense of resistance so
far, and quickly pull to start.
WWW.BORMANNTOOLS.COM