Storage And Transportation - BorMann PRO BGB3000 Manual

EN
Spark Arrester (if applicable)
1. Allow the engine to cool completely before servicing the spark arrester.
2. Remove the two screws holding the cover plate which retains the end of
the spark arrester to the muffler.
3.Remove the spark arrester screen.
4.Carefully remove the carbon deposits from the spark arrester screen with
a wire brush.
5.Replace the spark arrester if it is damaged.
6.Reinstall the spark arrester in the muffler and attach with the two screws.
Speed
The speed has been preset at the factory and should rarely require readjust-
ment. Consult your local authorized dealer for such needs.
WARNING:
Unapproved adjustment will damage your engine and/or your
electrical devices and void your warranty.
Adjustment
There has no other service and/or adjustment need for your generator. Un-
approved adjustments or tampering can damage your generator and your
electrical devices and will void your warranty. Contact your local dealer for
such needs.
WARNING: T
ampering with the factory set governor will damage your
generator and void your warranty.
V. Storage and transportation
Storage
The generating set should be started at least once every two weeks and al-
lowed to run for at least 20 minutes. Follow the instructions below for longer
term storage if the generatingset will be out of service for 2 months or more.
DANGER of fire or explosion
and extremely explosive. Empty the fuel tank and shut off fuel valve before
storing or transporting this generating set.
1. Allow the generating set to cool completely before storage.
2. Clean the generating set according to the instructions in the maintenance
section.
3. Drain all fuel completely from the fuel hose and carburetor to
prevent gum from forming.
4. Turn off the fuel supply at the fuel valve.
5. Change the oil.
6. Reattach the spark plug.
15
Gasoline is highly flammable
WWW.BORMANNTOOLS.COM
7. Remove the spark plug and pour about 15 ml of oil into the cylinder. Crank
the engine slowly to distribute the oil and lubncate the cylinder.
8. Store the unit in a clean, dry area out of direct sunlight. Transportation.
To prevent fuel spillage when transporting or during temporary storage, the
generating set should be secured upright in its normal operating position,
with the engine switch OFF. The fuel valve lever should be turned OFF.
WARNING:
Do not overfill the tank. Do not operate the generating set while it is on
vehicle. Take the generating set off the vehicle and use it in a well-ventilated
place. Avoid a place exposed to direct sunlight when putting the generating
set on a vehicle. If the generating set is left in an enclosed vehicle for many
hours, high temperature inside the vehicle could cause fuel to vaporize re-
sulting in a possible explosion. Do not drive on a rough road for an extended
period with the generating set on board. If you must transport the generating
set on a rough road, drain the fuel from the generating set beforehand.