Operating Location - BorMann PRO BGB3000 Manual

EN
The sealed battery on the generator is fully charged and pre-installed except for the negative (black) battery cable. install: Cut off tie wrapthat securing
the loose end of negative (black) cable. Connect the negative(black) battery cable to the negative (-)terminal on the battery. Verify if it is correct and
secure that the connections between the battery and generator .
D. Connect Negative Battery
III. Operation
1. Operating Check List
A. Operating Location
Only use OUTSIDE and place the generator in a well-ventilated area. Only operate the generator on a flat, level surface and in a clean, dry operating environment.
Allow two feet clearance on all side of the generator while operating it outdoors. Please consult your local authority. In some areas, generators must be registered
with the local utility. Generators used to construction sites may be subject to additional rules and regulations.
DANGER! TOXIC FUMES
The exhaust of the generator contains carbon monoxide, an odorless, colorless, poison gas. Using engine indoors CANKILL YOU! NEVER use inside any building
or any kind of enclosure, EVEN IF doors and windows are open.Place the generator In a well-ventilated area and carefully consider wind and air currents when
positioning generator.
High altitude
This engine may require a high altitude carburetor kit to ensure correct operation at high altitudes. Consult your local dealer for high altitude kit information if
you always operate your engine at altitudes above 5,000 feet (1,500 meters).
CAUTION! Even with carburetor modification, generator horsepower will decrease about 3.5% for each 1,000 feet (300 meters) increase in altitude. The effect of
altitude on horsepower will be greater than this if no carburetor modification is made.
CAUTION! Operation the engine at altitude below 5,000 feet (1,500 meters) with modified carburetor may cause the generator to overheand result in serious
engine damage.
2. Operating Condition
Check for loose or damaged arts, signs of oil or fuel leaks,and any other condition that may affect proper operation.Repair or replace all damaged or defective
parts immediately.
6
1. Chain
2. Push handle
3. Pin
1.Positive (+) terminal (red)
2.Negative (-) terminal (black)
WWW.BORMANNTOOLS.COM