Getting Started - BorMann PRO BGB3000 Manual

EN
DO NOT hook up any generator to a building electrical system without the proper use and installation of a transfer switch installed by a qualified electrician.When
using generator for backup power, notify utility company. Use approved transfer generator to isolate generator from electric utility. Failure to isolate generator
from power utility can result in death or injury to electric utility workers due to backfeed of electrical energy.
II. Getting Started
1. Unpacking
Remove the Generator form the Shippin Carton
1. Place the shipping carton on a solid, flad surface.
2. Carefully cut each corner of the carton box from top to bottom. Fold each side flat on the ground.
3. Remove everything from the carton except the generator.
2. Assembly
Y
our generator may require some assembly. If you have any questions regarding the assembly of your generator, please have your model number and serial
number ready and consult your local dealer for help.
A. Install Wheel Kit
Put wheel stop pin through wheel and mounting lug hole and then fix it with the clamp.
Note: A flat washer may be used to adjust the assembly clearance as needed
.
B. Install support bracket
The sealed batery on the generator is fully charged and pre-installed except for the negative (black) battery cable.
5
1. Clamp 2. Wheel 3. Washer 4. Wheel stop pin
1. Support bracket nut M8
2. Damping seat nut M6
3. Support bracket
4. Damping seat
5. Damping seat nut M6/18
6. Support bracket bolt M8/16
C. Install the handle
Use the handle pin to across and its mounting lug hole and then fix it
with the clamp.
WWW.BORMANNTOOLS.COM