Configuration In Ibapda; First Steps - IBA ibaPADU-4-AI-U Manual

ibaPADU-4-AI-U
9

Configuration in ibaPDA

The ibaPADU-4-AI-U device requires ibaPDA version 6.31.0 or higher.
9.1

First steps

1. Start the ibaPDA client and open the I/O manager
2. Choose the correct ibaFOB-D input card in the signal tree (on the left hand side) and
mark the link ibaPADU-4-AI-U is connected to. Right-click on the link and choose
"Autodetect".
ibaPDA recognizes the device automatically. The device will be listed in the signal
tree.
3. Alternatively you can manually add the device. Right-click on the link of the ibaFOB-D
card the device should be connected to. Select "Add module..." and then "ibaPADU-
4-AI-U".
The device will be listed in the signal tree.
Hold down the mouse button and drag the device to the address (link 1 – 15 below
the device), the device address switch is set to.
Position 1 – F refers to address 1 – 15.
4. Make your settings in the ibaPADU-4-AI-U module of the I/O Manager:
Manual
Issue 1.1 17