Connections; Fiber Optic Cable Connectors Rx / Tx; Power Supply; Analog Inputs X1 - IBA ibaPADU-4-AI-U Manual

ibaPADU-4-AI-U
7.3

Connections

7.3.1

Fiber optic cable connectors RX / TX

X11: Fiber optic reception interface (RX)
X10: Fiber optic transmission interface (TX)
Data is transmitted in 32Mbit Flex mode. ibaPDA requires a fiber optic card of the
ibaFOB-D family to receive and transmit data.
The fiber optic ports and transmitters are the physical base for a simple send-and-receive
connection to an ibaFOB card. The ports are designed for cables with 62.5/125 µm multi-
mode fibers and ST couplings which are available at iba too.
7.3.2

Power supply

The device requires an external DC 24 V ±10% power supply (unregulated) and should
be operated at a maximum of 0.4 A. The operating voltage should be run through the
provided 2-pin Phoenix threaded coupling connector. If desired, you can order DIN rails
or plug-in power supply units from iba.
7.3.3

Analog inputs X1

7.3.3.1 Filter
There are the following analog filters per channel:
Filter type
R/C low pass
Antialiasing Butterworth
Antialiasing digital
Figure 3: Filter sections
Manual
Order Cutoff
frequency
1. 72 kHz
4. 50 kHz
2 x 8. 1/3 of the adjusted sampling rate
Issue 1.1
in addition /
permanent
permanent
in addition (can be
activated only together)
13