Mounting And Dismounting; Mounting; Dismounting - IBA ibaPADU-4-AI-U Manual

6

Mounting and dismounting

6.1

Mounting

1. Locate the DIN rail mounting clip on the rear side of the device. Slowly push down
and in so that the bottom part of the mounting clips snaps onto the bottom part of the
rail and firmly fixes the device to the DIN rail.
2. Connect the 24 V DC power supply to the termination shown on the device. Ensure
that the polarity is correct prior to applying power. Then connect the device to the
ibaPDA system via a bidirectional FO cable.
6.2

Dismounting

1. Disconnect all external connections from the device.
2. Grasp the device with one hand firmly on the top side. With your free hand, grasp the
bottom of the device and push it lightly down.
3. After that pull the device and lift it up. With this action, the device should free itself
from the DIN rail.
10
Manual
Issue 1.1
ibaPADU-4-AI-U