Batch Counter - HANYOUNG NUX GE Series Instruction Manual

Power RUN - ON delay
Runs when Power is 'ON'
ON Output for T1 Time / OFF for T2 Time. Repetition
Initializes and stops when Reset is 'ON'
Signal START - ON delay
Maintains the indication of initial value when Power is 'ON'
Run when there is START (CP2) input
OFF Output for SET1 Time / ON for SET2 Time. Repetition
Initializes and stops when Reset is 'ON'
Signal START - ON delay
Maintains the indication of initial value when Power is 'ON'
Runs with the input of Start (CP2)
Output ON for SET1 time/repeat OFF for SET 2 times
Initializes and stops when Reset is'ON'
Power RUN / OFF time
Individual output control and setup pauce time
RUN when power is ON
Output OUT1 during SET1 time and OUT1 OFF during pause time
Output OUT2 during SET2 time and OUT2 OFF during pause time
and operations repeated
t: Possible to set up from 0 to 99.99 sec with pause time
Timer Action of Exclusive Indication (GE-T)
OFF set is available for up time range of Decimal system.(Press
second)
Power RUN
Runs after initializing the process value upon the authorization of Run Reset
Signal when Power is 'ON' Set Time is first to be reduced during Down Mode
Setup.
Runs when START (CP2) is 'ON', and resets when START (CP2) is 'OFF'
Set Time is first to be reduced during Down Mode Setup.

Batch Counter

1. Press
Enter to setup state, 6 rows (4rows) FND flickers, set "100" by pressing
2. Pressing
3. Pressing
setting
key for 2
Signal RUN
Batch Counting & Output Action
Batch counting value continues to increase until Batch Reset is authorized.
When batch coefficient value exceeds 999999 (4 rows 9999), it initializes to
0 and display
In case of batch display state (BAT lamp is lighted), press the
the front section to reset the batch value.
Even in the batch display state, counter/timer action operates normally.
Batch coefficient increases at the output of OUT2 (OUT).
Batch output is outputted as (BAT.O). (BAT.O lamp is lighted)
Instant Output Setup
Function switches over to instant output when the batch value is set at 0.
(BAT.O lamp is lighted)
Batch Counter setup Method
key
/ key (When use want to set 100 batch.)
key will complete setup. (Pressing
changing)
key will return to operation mode. (Left side BAT lamp off)
Properly operates within BATCH display mode
Possible to setup BAT only with
key on
key will exit without
, BAT setting.