HANYOUNG NUX GE Series Instruction Manual page 7

Signal START / ON delay
Run when START (CP2) is 'ON' within the initial setup value
When setup time exceeds, display value will maintain and output (one short
output with setting).
Signal START / ON delay (Counter F output mode operation)
- RUN when initial setup value of START (CP2) is ON
- When setup time exceeds, display value will increase and put out the output (one
short output with Setting
Signal RUN / ON delay
Run when CP2 (START) is 'ON' within the initial setup value and when 'OFF', it RESET
When setup time exceeds, it maintains display value and output time
Signal RUN / OFF delay
When START (CP2) is 'ON' then output become 'ON' and time will display
initial value.
Time activates the initial value to run when START (CP2) is 'OFF'.
The initial value is initialized and output is 'OFF' when the set time elapses.
Interval / Signal RUN
Runs when START (CP2) is 'ON' and resets when 'OFF'
Output is 'ON'during the set time, and the initial value is initialized and output
is 'OFF' when the set time elapses.
Interval / Signal START
Runs when START (CP2) is 'ON'.
Output is 'ON' during the set time, and the indicated value is initialized and
output is 'OFF' when the set time elapses.
Flicker / Signal START
[HOLD] Setup (when output time [OUTT] is set at 0[HOLD])
Setup Set Time in Run Mode
Maintains the indication of initial value when Power is 'ON'
Runs when becomes START (CP2).
ON/OFF Repetitious Action of control output after reaching the Set Time.
Initializes and stops when Reset is 'ON'
ONE SHOT TIME Setup (when output time [OUTT] is set at more than 1)
Setup Set2 Time in Run Mode.
Maintains the indication of initial value when Power is 'ON'
Runs when Power is 'ON'
One Shot Output after reaching the Set Time.
Initializes and stops when Reset is 'ON'
Flicker / Signal START
Same operation as counter output mode
Signal Addition
RUN when START (CP2) maintains ON and it will become HOLD when it is
OFF (cumulative Timer Function)
No output operation within Down time range
Twin Timer[TTIM]Output Action
Power RUN - ON delay
Runs when Power is 'ON'
OFF Output for T1 Time / ON for T2 Time. Repetition
Initializes and stops when Reset is 'ON'