Pro Connect Removal and Assembly
Power Head Removal
1.
Set speed control to Setting 1 and jog
Power Head to position the piston and
slider in the bottom dead center position.
This step will make re-assembly easier.
2.
Remove battery, see Battery
Installation and Removal, page 15.
3.
Perform Pressure Relief Procedure,
page 17.
3A8110C
Pro Connect Removal and Assembly
4.
Remove locking screw and loosen
thumb screw. Rotate cover open.
5.
Grab Power Head by motor vents and
pull the Power Head off the pump.
Support Power Head with two hands, if
necessary.
25