Table of Contents
Advertisement
Start Up
Start Up
1.
Prior to dispensing, mix material as
necessary.
2.
Insert pump into bucket of material and
adjust the bucket stabilizing bracket to
desired height.
3.
If desired, secure foot bracket to
mounting surface to increase stability.
16
4.
Apply Throat Seal Liquid (TSL) into
pump throat.
5.
Install battery on the Power Head, see
Battery Installation and Removal,
page 15.
6.
Set speed control to setting 5 and press
pump dispense button to prime the unit
until material comes out of the outlet port
(~5 seconds).
NOTE: If unit doesn't prime within 10
seconds of pumping, pour water into outlet to
wet pump and repeat. If pump doesn't prime,
refer to Troubleshooting, page 27.
3A8110C
Advertisement
Table of Contents
