Menu #2 - Advanced Features - Clarion SR9000 Installation Manual

Clarion sr9000 cctv systems: installation guide

Hide thumbs Also See for SR9000:

Owner's manual (53 pages)

Table of Contents

1-8 FORCED PASSIVE ARMING ON/OFF: To use this feature, passive arming must be selected in Feature 1-1. When

turned on, forced passive arming will ensure that the system will passively arm, even if a zone is left open or

invalid. Forced passive arming occurs one hour after the ignition is turned off.

1-9 AUTOMATIC ENGINE DISABLE (AED) ON/OFF: AED is a full-time, passive starter disable that works inde-

pendently of the security system. When turned on, the orange, ground-when-armed output (H1/1) will activate

30 seconds after the ignition is turned off. The LED will flash at half its normal rate when the ignition is turned

off to indicate that AED is active and will interrupt the starter in 30 seconds. AED does not occur in Valet mode

and can be bypassed using the emergency override procedure. The transmitter can be used to disarm AED,

however, the system must be armed and then disarmed, using the transmitter, to disarm AED.

1-10 ARMED WHILE DRIVING (AWD) ON/OFF: In the default setting (Armed While Driving), the system can be

armed with the ignition on. When armed, the ground-when-armed is not active and the sensors are bypassed.

The door triggers will remain active.

1-11 CODE HOPPING® ON/OFF: The system uses a mathematical formula to change its code each time the trans-

mitter and receiver communicate. This makes the group of bits or "word" from the transmitter very long. The

longer the word is, the easier it is to block its transmission to the unit. Disabling the Code Hopping® feature lets

the receiver ignore the Code Hopping® part of the transmitted word. As a result, the unit may have better range

with Code Hopping® off.

1-12 HORN OUTPUT PULSED/CONSTANT: Program for either a pulsed output or a continuous output when trig-

gered.

1-13 HORN FUNCTION (FULL ALARM ONLY)/SIREN FUNCTION (20mS, 30mS, 40mS, 50mS): Program for output

when the alarm is fully triggered or as the siren (arming/disarming and warnaway and full trigger with timing

options).

1-14 COMFORT CLOSURE—ON, OFF: The system can be programmed to close the windows when the system is armed.

A 20-second output starts 200mS after the last lock pulse. The Comfort Closure output will be canceled if the unlock

button is pressed. If programmed ON, the lock output wire provides this function.