Parts and Exploded View… ........Page 11 Unpacking and Setup ..........Page 4 Wiring Diagram ............Page 12 Installation… ..............Page 5 1600 Xenium Lane N. • Plymouth, MN 55441 USA Telephone: 800-328-3329 • www.silverking.com SK-2 Cream Dispenser Printed in USA 1/21...
Five (5) Year Compressor Warranty Silver King warrants to the original purchaser for a period of five (5) years from the date of original purchase or five (5) years and one (1) month from the date of shipment from the factory, whichever comes first, that it will replace the compressor with one of similar design and capacity, exclusive of delivery and installation charges, if it is found to Silver King’s satisfaction to...
Safety Information General WARNING The SK-2 Cream Dispenser is designed to hold and dispense bulk cream. It will dispense 1 – 10 shots of cream Indicates information important to the proper operation of the corresponding with the displayed buttons 1 – 10.
Marmon Foodservice The standard unit is equipped with a seven (7) foot Technologies nor its Silver King division. power cord that requires a 115 Volt, 60 Cycle, 1 Phase, properly grounded electrical receptacle, protected with a 15 or 20 ampere fuse or breaker.
94g is shown. Press 6 to confirm. Repeat calibration until 99g is dispensed. Sanitize the valve and valve area. With an approved sanitizing solution, thoroughly clean the valve and valve The dispenser is now ready to use. area. Allow to air dry. SK-2 Cream Dispenser...
1,2,3…10 shots of cream. cleaned daily with a clean cloth to prevent buildup which could affect the dispensing of the correct amount of cream. SK-2 Cream Dispenser...
Cream Dispenser Model SK-2 Manager Mode Flowchart SK-2 Cream Dispenser...
Page 10
Clean drip tray. Take the drip tray to 3 compartment sink to wash, Refill Creamer. In- rinse, and sanitize sert a new bag of cream into dispenser. Pull and turn valve to secure cream tube. Replace the drip tray. SK-2 Cream Dispenser...
Call for service (888-375-2938). System undercharged from factory Call for service (888-375-2938). System overcharged Call for service (888-375-2938). System not clean Call for service (888-375-2938). Restricted filter drier Call for service (888-375-2938). Restricted capillary tube Call for service (888-375-2938). SK-2 Cream Dispenser...
Page 12
Compressor vibrating on cabinet frame Call for service (888-375-2938). Beverage leaking or not flowing Tube Kinked Remove valve and pull tube straight through valve area. Valve stuck Clean valve and valve area or call for service (888-375-2938). SK-2 Cream Dispenser...