6.2
Mounting
Caution! The device can sustain damage when coming into contact with
hard objects!
The plastic parts of the device are sensitive.
–
–
The flush-mounted insert must only be installed in flush-mounted wall boxes according to DIN
49073-1, Part 1, or suitable surface-mounted housings.
Fig. 1:
Wall mounting: pulling off the attachment
To install the device, perform the following steps:
Fig. 2:
State of the device at the point of delivery:
pulling off the attachment
Operating Instructions 2CKA001473B8822
Pull the attachment off only with your hands.
Do not lever parts off with screwdrivers or similar hard objects.
Connection, installation / mounting
–
If the device is already mounted or
assembled, pull off the attachment
from the flush-mounted insert with
the aid of the cover frame.
–
If the state of the device is at the
point of delivery, pull off the
attachment from the flush-mounted
insert with your hands.
–
Pull the attachment off only with your
hands!
–
Do not lever parts off with
screwdrivers or similar hard objects.
This damages the device.
–
When pulling off, first the resistance
of the spring clamps must be
overcome.
│15