Specifications; General Power Tool Safety Warnings; Save All Warnings And Instructions For Future Reference - Makita JN3201 Instruction Manual

ENGLISH
1. Stainless steel gauge 2.5 mm
(3/32")
2. Mild steel gauge 3.2 mm (1/8")
3. Switch trigger
4. Lock button
5. Wrench
6. Lock nut
7. Die holder
8. Punch

SPECIFICATIONS

Max. cutting capacities
Min. cutting radius
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2014
Symbols
The followings show the symbols used for the equipment.
Be sure that you understand their meaning before use.
.............. Read instruction manual.
.............. DOUBLE INSULATION
Intended use
The tool is intended for cutting sheet steel and stainless
sheet steel.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
4
Explanation of general view
9. Screw
10. Cutting edge
11. Groove
12. Punch holder
13. Pin
14. Hex wrench
15. Washer
16. Insert washer in between
17. Die
Model
Steel up to 400 N/mm
Steel up to 600 N/mm
Steel up to 800 N/mm
Aluminum up to 200 N/mm
Strokes per minute (min
Overall length
Net weight
Safety class
END201-7
ENE037-1
ENF002-2
2
2
2
2
Outside edge
Inside edge
-1
)
General power tool safety
warnings
WARNING: Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
Save all warnings and
instructions for future reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
Work area safety
1. Keep work area clean and well lit. Cluttered or dark
areas invite accidents.
2. Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases or dust. Power tools
create sparks which may ignite the dust or fumes.
3. Keep children and bystanders away while
operating a power tool. Distractions can cause you
to lose control.
18. Grind/sharpen; 0.3 - 0.4 mm
(1/64")
19. Remove dull portion
20. 3.5 - 4.0 mm (1/8" - 5/32")
21. Limit mark
22. Screwdriver
23. Brush holder cap
JN3201
3.2 mm / 10 ga
2.5 mm / 13 ga
1.0 mm / 20 ga
3.5 mm / 10 ga
128 mm
120 mm
1,300
225 mm
3.4 kg
/II
GEA012-2