Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
1. Remove all packing materials from the oven cavity and the feature sticker from the oven door panel (if available).
Check the unit for any damage, such as a misaligned door, damaged door seals around the door or dents inside
the oven cavity or on the door. If there is any damage, please do not operate the oven until it has been checked
by the SHARP SERVICE CENTRE and repaired, if necessary.
2. Accessories provided
1) Turntable
3. Place the roller stay in the coupling on the oven fl oor, then place the turntable on to the roller stay, ensuring it is
located fi rmly. Refer to OVEN DIAGRAM below. NEVER operate the oven without the roller stay and turntable.
4. This oven is designed to be used on a countertop only. It should not be installed in any area where heat and
steam are generated, for example, next to a conventional oven unit.
The oven should be installed so as not to block ventilation openings.
Allow space of at least 15cm from top of the oven for air ventilation.
This oven is not designed to be built-in to a wall or cabinet.
5. Neither the manufacturer nor the distributors can accept any liability for damage to the machine or personal injury
for failure to observe the correct electrical connecting procedure.
The A.C. voltage and frequency must correspond to the one indicated on the rating label on the back of the
oven.
6. This appliance must be earthed:
The wires in power supply cord are coloured in accordance with the following code:
As the colours of the wires in the power supply cord of this appliance may not correspond with the coloured marking
identifying the terminals in your plug, proceed as follows:
The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked with the
letter E or by the earth symbol
The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured
blue.
The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured
brown.
OVEN DIAGRAM
1. Door open button
2. Oven lamp
3. Door hinges
4. Door safety latches
5. See through door
6. Door seals and sealing surfaces
7. Coupling
R-380V(S)_[01 EN].indd Sec1:4
R-380V(S)_[01 EN].indd Sec1:4
2) Roller Stay
3) Operation Manual
IMPORTANT
Green-and-yellow
Blue
Brown
or coloured green or green-and-yellow.
:
Earth
:
Neutral
:
Live
8. Waveguide cover (Do not remove)
9. Touch control panel (See page E-5)
10. Liquid crystal display
11. Ventilation openings
12. Power supply cord
13. Turntable
14. Roller stay
15. Rating label
E-4
2/14/12 1:49:46 PM
2/14/12 1:49:46 PM
Advertisement
Table of Contents
