Product Safety Information; Product Specifications; Installation And Lubrication - Ingersoll-Rand 236 Instructions Manual

Product Safety Information

Intended Use:
These Impact Wrenches are designed to remove and install threaded fasteners.
For additional information refer to Product Safety Information Manual Form 04580916.
Manuals can be downloaded from ingersollrandproducts.com.
Power Management System
For models that include a power management system, the system allows operator reduction of
maximum output power.
To adjust the power, rotate the Power Regulator to the desired level indicator.
The power level indicators are for reference and DO NOT indicate a specific power. The power
output can be further reduced in forward or reverse by using the variable throttle.

Product Specifications

Model Style
236 Pistol
Model
† Pressure (L
236
† K = 3dB measurement uncertainty
pA
‡ K = 3dB measurement uncertainty
wA
Sound and vibration values were measured in compliance with internationally recognized
test standards. The exposure to the user in a specific tool application may vary from these
results. Therefore, on site measurements should be used to determine the hazard level in
that specific application.

Installation and Lubrication

Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install a
properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any hose
coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling
disconnects. See drawing 47132600 and table on page 2. Maintenance frequency is shown in a
circular arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Air filter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5. Hose diameter
6. Thread size
80198336_ed4
Drive
Impacts
per min.
Type Size
Square 1/2" 1200
Sound Level dB(A)
(ISO15744)
)
p
90.3
WARNING
Recommended Torque Range
Forward
ft-lb (Nm)
25 - 200 (34 - 271)
‡ Power (L )
w
101.3
* K = Vibration measurement uncertainty
7. Coupling
8. Safety Air Fuse
9. Oil
10. Grease - during assembly
11. Grease - through fitting
EN
Reverse
ft-lb (Nm)
25 - 200 (34 - 271)
Vibration (m/s²)
(ISO28927)
Level *K
12.0 1.0
EN-1