Table of Contents
Advertisement
b) Enable either DHCP (preferred for newer installations) or a static IP (using information provided
by the installation site or the Hercules modem being used) using the DHCP En/Disable button
(and other buttons if using static).
c) Once your information has been input, press the Cancel key to save the changes.
NOTE: If you have switched from Static to DHCP or vice versa, you may need to reboot the ATM now or
after completing the remaining steps. See how to reboot your ATM under "Testing SSL" below.
Alternative: Static IP Configuration
The Hercules can also be used with a static IP configuration. If that is required, use the information
provided below and your ATM will be connected to the Hercules. Use the DHCP En/Disable button to
switch to static configuration and enter the following:
• IP Address: 192.168.0.55
• Subnet Mask: 255.255.255.0
• Gateway: 192.168.0.1
• DNS: 192.168.0.1
ATM Operator Menu > System Setup > Terminal IP
5
Hide quick links:
Advertisement
Table of Contents
