Midea MLH27N5AWWC User's Manual & Installation Instructions page 38

WARNING
You can't use the emergency cord when your washer is running. If you
must open the door, turn your washer off and wait for the water to cool
before you use the emergency cord.
•
Open the filter door located on the bottom right of the front of your
washer.
•
Gently pull the emergency cord down.
NOTE:
•
Open the your washer's door.
•
Restore the cord to its original position, then close the filter door.
Unfreezing your washer
If the ambient temperature drops to freezing (32° F /0°C), any water in
the pipes or water hoses may freeze.
•
Unplug the power cord.
•
Wash the water faucets with warm water to loosen the inlet hose.
•
Remove the water hoses and immerse them in warm water.
•
Pour warm water into the washing drum and wait for 10 minutes.
•
Reconnect the water hoses to the water faucets and make sure that
there are no leaks.
•
Run your washer on the Drain Only cycle to remove any water you
added.
Storing your washer
You can damage your washer if you don't remove water from hoses and
internal components before storage.
To prepare your washer for storage:
•
Select the Quick Wash cycle and add bleach to your washer. Run
your washer through the cycle without a load.
•
Turn the water faucets off and disconnect the inlet hoses.
•
Unplug your washer from the electrical outlet and leave your
washe's door open to let air circulate inside the tub.
38
Don't pull hard on the cord. You might break it. Pull gently.
Emergency
release cord