Midea MLH27N5AWWC User's Manual & Installation Instructions page 15

•
A grounded electrical outlet located within 6 ft. (1.8 m) of where the
power cord is attached to the back of the washer. See Electrical
requirements on page 11.
•
Hot and cold water faucets located within 4 ft. (1.2 m) of the hot and
cold water fill valves, and water pressure of between 0.05MPa~1MPa.
•
A level floor with a maximum slope of 1 in. (25 mm) under entire
washer. Don't install your washer on soft floor surfaces, such as
carpets or surfaces with foam backing.
•
A sturdy and solid floor to support the washer with a total weight
(water and load) of 200 lbs. (90 kg)
Make sure that the location is:
•
Away from direct sunlight. Direct sunlight can raise the water
temperature, which may cause safety risks.
•
An area where the temperature is above 32° F (0° C).
•
Away from the heat resources such as coal or gas. Heat sources can
raise the water temperature, which may cause safety risks.
Washer dimensions and installation measurements
23.5 in. (59.5 cm)
42.5 in. (108 cm)
25.6 in. (65 cm)
33.5 in. (85 cm)
15