Atag VA5113BT User Manual page 37

programme you want to select starts
flashing.
4. Close the appliance door to start the
programme.
Starting a programme with
delay start
1. Set a programme.
2. Press the delay button to delay the
start of the programme by 3 hours.
The indicator is on.
3. Close the appliance door to start the
countdown.
During the countdown, it is not possible to
change the programme.
When the countdown is complete, the
programme starts.
Opening the door while the
appliance operates
Opening the door while a programme is
running stops the appliance. It may affect
the energy consumption and the
programme duration. After closing the
door, the appliance continues from the
point of interruption.
If the door is opened for more
than 30 seconds during the
drying phase, the running
programme ends. It does not
happen if the door is opened by
AirDry function.
Do not try to close the
appliance door within 2 minutes
after AirDry automatically
opens it as this may cause
damage to the appliance.
If, afterwards, the door is
closed for at least 3 minutes,
the running programme ends.
Cancelling the delay start
Press the on/off button for 3 seconds until
the appliance is in programme selection
mode.
When you cancel the delay start, you have
to set the programme again.
Cancelling the programme
Press the on/off button for 3 seconds until
the appliance is in programme selection
mode.
Make sure that there is detergent in the
detergent dispenser before you start a
new programme.
The Auto Off function
This function decreases energy
consumption by deactivating automatically
the appliance when it is not operating.
The function comes into operation:
• When the programme is complete.
• After 5 minutes if a programme was not
started.
End of the programme
When the programme is complete, the
Auto Off function switches the appliance
off.
Close the water tap.
37