Before First Use - Atag VA5113BT User Manual

1. Press the programme button three
times.
The indicator starts to flash.
2. Wait until the indicator
to flash and the remaining programme
indicators are off.
The indicator shows the current
setting:

BEFORE FIRST USE

1. Make sure that the current level of
the water softener agrees with the
hardness of the water supply. If not,
adjust the level of the water
softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any
processing residuals that can still be
inside the appliance. Do not use
detergent and do not put dishes in the
baskets.
After starting the programme, the
appliance recharges the resin in the water
softener for up to 5 minutes. The washing
phase starts only after this procedure is
complete. The procedure is repeated
periodically.
The salt container
CAUTION! Use rough salt
designed for dishwashers only.
Fine salt increases the risk of
corrosion.
The salt is used to recharge the resin in
the water softener and to assure good
washing results in daily use.
How to fill the salt container
1. Turn the cap of the salt container
counterclockwise and remove it.
2. Put 1 litre of water in the salt container
(only for the first time).
3. Fill the salt container with 1 kg of salt
(until it is full).
3. Press the programme button to
continues
4. Press the on/off button to confirm the
4. Carefully shake the funnel by its
5. Remove the salt around the opening of
6. Turn the cap of the salt container
• is off = AirDry is off.
• is on = AirDry is on.
change the setting.
setting.
handle to get the last granules inside.
the salt container.
clockwise to close the salt container.
CAUTION! Water and salt can
come out of the salt container
when you fill it. After you fill the
salt container, immediately
start a programme to prevent
corrosion.
35