Replacing A Storage Module - Fujitsu PRIMERGY BX620 S4 Options Manual

Storage Modules
Figure 32: Installing the BBU Card
Ê Push the BBU card into the slot on the riser card (1) as far as it will go.
Ê Let the two ejection tabs on the right and left engage in the notches of the
BBU card (2).
How to install the storage module in the server blade is described in the
following section.
8.2

Replacing a Storage Module

V
CAUTION!
Please observe the safety information in the chapter ";Safety Instruc-
tions" on
You must switch off the server blade before replacing the storage
module (non-hot-plug).
All variants of the storage module are installed and removed in the same way.
This section shows the steps using a BX620 S4 SAS/PCI-X module fitted with
a Fibre-Channel PCI controller as an example.
BX620 S4
1
2
page 13ff..
Options Guide
Replacing a Storage Module
1
2
51