Uplink Ports; The Back Panel; Power Port - Cisco SGE2000 Administration Manual

Linksys One Ready Communications Solution
2

Uplink Ports

The Switch is equipped with 4 mini-GBIC uplink ports.
GBIC1-4 The Switch provides four mini-GBIC ports. The mini-GBIC port is a
connection point for a mini-GBIC expansion module, so the Switch can
be uplinked via fiber or copper to another switch. Each mini-GBIC port
provides a link to a high-speed network segment or individual
workstation at speeds of up to 1000Mbps.
Use the Linksys MGBT1, MGBSX1, or MGBLH1 mini-GBIC modules
with the Switch. The MGBSX1 and the MGBLH1 require fiber cabling
with LC connectors, while the MGBT1 requires a Category 5e Ethernet
cable with an RJ-45 connector.

The Back Panel

The power port is located on the back panel of the Ethernet switch.
1

Power Port

The 100-240 VAC power cord is connected to the Power port.
Chapter 2: Getting to Know the Switch
The Back Panel
2
DC INPUT FOR REMOTE
POWER SUPPLY SPECIFIED
IN MANUAL +12V, 7.5A
CAUTION: Only use the power cord
that is supplied with the Ethernet switch.
The unit may be damaged if the
incorrect power cord is used.
Power Port. The Power port is where you will
connect the power cord. For more details, refer to
1
"Power Port," on page 6
Console Port. The Console port is where you can
connect a serial cable to a PC's serial port for
2
3
configuration. For more details, refer to
Port," on page 7
RPS Port. Redundant Power Supply (RPS) port. For
3
more details, refer to
.
"Console
.
"RPS Port," on page 7
.
6