Supported Chassis, Line Cards, And Modules; Unsupported Hardware And Features; Rsp720 With 10Ge Uplink Ports - Cisco WS-SUP720-3B - Supervisor Engine 720 User Manual

RSP720 with 10GE Uplink Ports

Supported Chassis, Line Cards, and Modules

The RSP720 supports the following Cisco 7600 chassis, line cards and modules:
•
•
•
•
•
•

Unsupported Hardware and Features

The following hardware and features are not supported by the RSP720:
•
•
RSP720 with 10GE Uplink Ports
Cisco IOS Release 12.2SRC introduces a new RSP720 with 10 Gigabit Ethernet (GE) uplink ports
(RSP720-10GE). The Cisco 7600 RSP720-10GE consists of a full-size board and two integrated
daughter cards: an MSFC4 and a PFC. The RSP720-10GE has an integrated switch fabric that
interconnects all of the line cards in the router with point-to-point 20-Gbps full-duplex serial channels.
Two versions of the RSP720-10GE module are available:
•
•
Because of physical differences between the RSP720 and RSP720-10GE (such as the CPU memory map
and ASIC operation), there are several configuration guidelines and restrictions you should be aware of.
See the
Following are the total power requirements for the RSP720-10GE:
•
•
Figure 2-2
See
Cisco 7600 Series Router Supervisor Engine and Route Switch Processor Guide
2-10
Supported on all Cisco 7600 routers (including enhanced chassis) except the Cisco 7603 and the
Cisco OSR-7609
SPA interface processors (SIPs) and their shared port adapters (SPAs): 7600-SIP-600,
7600-SIP-400, and 7600-SIP-200
Enhanced FlexWAN module (WS-X6582-2PA)
Ethernet services modules: 2-port 10 GE line card (7600-ESM-2X10GE) and 20-port 1 GE line card
(7600-ESM-20X1GE)
Distributed Forwarding Cards: DFC3C, DFC3CXL, DFC3B, DFC3BXL
LAN cards (which require CFC or DFC):
– WS-X67xx
– WS-X65xx
– WS-X64xx
WS-X63xx
–
WS-X61xx
–
Unsupported chassis: Cisco 7603, Cisco OSR-7609.
Unsupported modules: Services modules, Optical Service Modules (OSMs), FlexWAN module.
RSP720-3C-10GE
RSP720-3CXL-10GE
"RSP720-10GE Usage Guidelines and Limitations" section on page 2-13
RSP720-3C-10GE = 355 watts (total power)
RSP720-3CXL-10GE = 378 watts (total power)
shows the RSP720-3C-10GE front panel. The RSP720-3CXL-10GE front panel is similar.
Table 2-8 and Table 2-9 for information about the front-panel controls and LEDs.
Chapter 2 Route Switch Processors and Supervisor Engines
for details.
OL-10100-11