Daktronics Large Matrix Galaxy GS6 Series Installation Quick Manual

Large Matrix Galaxy
Installation Quick Guide
Mount Display
For Multi-Section Displays – See Section Splice
Instructions (p.3).
1. Lift the display into position on support
structure. Refer to label at lift eyes for
information.
• Maintain a 55-degree or greater angle
between display and lift straps.
• Do not adjust or remove lift eyes.
• Do not lift display in wind speeds greater
than 20 mph.
Angle must be
greater than 55°
2. Weld or bolt ALL T-clips to support structure.
Note: T-clips can be adjusted within the
guidelines of the label located at each
T-clip.
T-CLIP CAN BE ADJUSTED BUT MUST FALL BETWEEN LINES
DD3125329
Rev 02
25 June 2020
GS6 and GT6X Series
®
Connect Power
Note: GT6X displays have multiple power
1. Route conduit from the main distribution
panel/disconnect to each display power
entrance. In GT6X displays, each display
section has a power entrance and requires a
dedicated circuit
2. Remove the four screws that attach the power
entrance access door.
3. Connect conduit to the 1
left of the power entrance box.
4. Feed power cable from the conduit into the
power entrance box.
5. Connect primary power lines to appropriate
taps in enclosure – refer to label on enclosure
for wiring diagram.
6. Reinstall power entrance cover.
201 Daktronics Drive
Brookings, SD 57006-5128
www.daktronics.com/support
800.325.8766
Page 1 of 3
entrances depending upon the display
length.
/
1
" Myers hub at the
4