Section 3-Handling; Unpacking; Inspection; Storage - Invacare Perfecto2 Series Operator's Manual

SECTION 3—HANDLING
The concentrator should ALWAYS be kept in the upright
position to prevent cabinet damage while being transported.
If the concentrator is to be reshipped by common carrier,
additional cartons are available from Invacare.

Unpacking

NOTE: For this procedure, refer to FIGURE 3.1.
1. Check for any obvious
damage to the carton or
its contents. If damage is
evident, notify the
carrier, or your local
dealer.
2. Remove all loose packing
from the carton.
3. Carefully remove all the
components from the
carton.
NOTE: Unless the oxygen concentrator is to be used
IMMEDIATELY, leave concentrator in its packaging for storage
until use of the concentrator is required.

Inspection

1. Inspect/examine exterior of the oxygen concentrator for
nicks, dents, scratches or other damages. Inspect all
components.

Storage

1. Store the repackaged oxygen concentrator in a dry area.
2. DO NOT place objects on top of repackaged concentrator.
Part No 1163145
SECTION 3—HANDLING
FIGURE 3.1 Unpacking
11 Perfecto ™Series
2