Mounting The Sunny Boy On A Wall Mounting Bracket - SMA SUNNY BOY 5000-US Installation Manual

SMA America, LLC

5.3.4 Mounting the Sunny Boy on a Wall Mounting Bracket

CAUTION
The Sunny Boy may fall over due to its heavy weight.
Risk of bruising and broken bones.
• When mounting the Sunny Boy, note that it has a weight of 148 lbs. (67 kg).
1. Remove the handle covers on the right and left side of the Sunny Boy.
Move the Sunny Boy up and down onto the side handles (job for 2 people).
or
Feed a steel rod with a maximum diameter of 1
at the top. Have two people move the Sunny Boy.
2. Hook the Sunny Boy with the enclosure opening
onto the rear panel in the wall mounting bracket. The
Sunny Boy must be seated on the middle of the wall
mounting bracket.
3. Screw the Sunny Boy onto the wall mounting bracket
on both sides with the screws supplied.
4. Tighten the screws clockwise with a tightening torque
of 44 in-lbs. (5 Nm).
5. Place handle covers on the handles.
To help you identify the sides, the ventilation grids
are labeled "rechts/right" and "links/left" on the
inside.
The ventilation grilles prevent dirt and insects from
entering the inverter and can be reordered from
SMA if required. See section 12 "Accessories"
(page 100).
Installation Guide
1
⁄ in. (30 mm) through the enclosure openings
8
SB50US-80US-eng-IUS112633
Mounting
33