Mounting The Sunny Boy On A Wall Mounting Bracket - SMA Sunny Boy 6000TL‑US Installation Manual

SMA America, LLC
4.3.1 Mounting the Sunny Boy on a Wall Mounting Bracket
1. Remove the handle covers on the right and left side of the Sunny Boy.
2.
The Sunny Boy may fall down due to inappropriate mounting
Contusions or bone fractures due to the heavy weight of the Sunny Boy.
• Transport the Sunny Boy between two persons, using the side handles above and below.
or
Put a steel bar with a maximum diameter of 1
above and transport it between two people.
3. Hook the Sunny Boy with the enclosure opening
onto the rear panel in the wall mounting bracket. The
Sunny Boy must be seated on the middle of the wall
mounting bracket.
4. Screw the Sunny Boy onto the wall mounting bracket
on both sides with the screws supplied.
5. Tighten the screws clockwise with a tightening torque
of 44 in-lb. (5 Nm).
6. Plug handle covers on the handles.
To help you identify the sides, the ventilation grids
are marked "rechts/right" and "links/left" on the
inside.
The ventilation grids prevent dirt and insects from
entering the inverter and can be reordered from
SMA if required. See Section 12 "Spare Parts and
Accessories", page 88
Installation Manual
1
⁄ in. (30 mm) through the enclosure opening
8
SB6-11TL-US-IA-en-13
4 Mounting
27