Table of Contents
Advertisement
O
PERATING MANUAL
3. Check of the brake actuating lever
It must be possible to push the anchor rods coming up out of the two
brake magnets with your thumb (see Fig. 7.4.2) and they must have
buffering, easy moving characteristics when operation involves
jolting.
Anchor rod
Brake magnet
If a defect occurs with regard to points 2. or 3., in general both
accessory brake actuating levers (see Fig. 7.4.1) are to be replaced!
The replacement is to be requested through ThyssenKrupp Aufzugswerke.
See replacement kit no. 6144 000 9209
7.5
Replacing brake shoes
Note: With a remaining lining thickness less than or equal to 3 mm, or if the
brake linings have become unusable and the required deceleration is not
achieved, the brake linings have to be replaced.
In order to achieve the same braking effect after replacing the shoes, it is
necessary to measure and note down the setting of the initial spring tension
before removal. See Fig. 7.4, dimension "A"
ThyssenKrupp Aufzugswerke GmbH
DAB450
Fig. 7.4.2
41
M
/
AINTENANCE
SERVICE
Version 03/2017
Advertisement
Table of Contents
