Stiga stig Instruction Manual page 46

4.3.4. SCHEDULED PROGRAM / SINGLE WORK CYCLE SELECTION - SCHEDULED PROGRAM
BUTTON
The "SCHEDULED PROGRAM" button (F) allows to activate or deactivate the work schedule set through
the App.
• If the button (F) is illuminated in green, the robot lawn mower works according to the scheduled
work program (also see Par. 3.7.7, see Par. 3.7.8 for programming).
• If the button (F) is off, the robot lawn mower works by performing a single work cycle and then
returns to the charging base (also see Par. 3.7.7).
Procedure:
1. Press the button "STOP" (A) to open the cover (B) and access the control console (C).
2. It's possible to switch from the scheduled work to single work cycle by pressing the "SCHEDULED
PROGRAM" button (F).
3. To start the robot lawn mower, proceed as follows depending on the case:
• If the scheduled program is active, perform one of the following actions:
- Robot lawn mower inside the charging base:
- close the cover (B), the robot will follow the scheduled program;
- Press the "START" button (M) to set the robot in working mode, the button lights up. If the
robot lawn mower is not within the scheduled working time, it will perform a work cycle,
return to base and resume operation as per the scheduled program.
- Robot lawn mower outside the charging base:
- Press the "RETURN TO BASE" button (G) to send the robot to the charging base, the
button lights up;
- Press the "START" button (M) to set the robot in working mode, the button lights up. If the
robot lawn mower is not within the scheduled working time, it will perform a work cycle,
return to base and resume operation as per the scheduled program.
• If the scheduled program is not active, follow one of the following actions:
- Press the "RETURN TO BASE" button (G) to send the robot to the charging base, the button
lights up;
- Press the "START" button (M) to set the robot in working mode, the button lights up.
4. Close the cover (B).
A C
46
4. OPERATION
B
F G M
EN