Stiga stig Instruction Manual page 43

4.2. MANUAL FUNCTIONING OF THE ROBOT LAWN MOWER
The robot lawn mower can be used without performing the described programming (see Par. 3.7). In this
mode the robot lawn mower carries out a work cycle, returns to the charging base and remains there until
the next manual start.
Procedure:
1. Put the robot on the charging base in the installation perimeter, or in any case inside the installation
perimeter.
2. Press the button "STOP" (A) to open the cover (B) and access the control console (C).
3. Press the button "ON/OFF" (E) for 3 seconds to switch on the robot lawn mower.
4. Make sure that the button (F) is off; if it's on, press it to turn it off.
5. Press the "START" button (M) and it will start flashing.
6. Close the cover (B) and the robot lawn mower will enter into operating mode.
A C
NOTE: this mode may not guarantee adequate coverage of the garden, both in terms of time
required and in terms of uniformity of the cutting result, especially if the garden has an irregular
shape. To achieve the maximum efficiency of the robot lawn mower, it is recommended to carry
out programming (see Par. 3.7).
EN
B F E M
4. OPERATION
43