Stiga stig Instruction Manual page 29

3.5.3. CHARGING BASE INSTALLATION
CAUTION:
Danger of cutting hands.
ELECTRICAL HAZARD:
Connect the power supply only at the end of
all the installation operations. If necessary
during the installation, turn off the general
power supply.
Requirements and obligations:
• Flat land
• Charging base
• Power supply
• Screwdriver
• Electrician's scissors
• Glasses
GLOVES OBLIGATION:
Use protective gloves to avoid
cutting your hands.
The charging base can be installed:
• aligned with the perimeter cable so that the robot can access it by navigating the perimeter cable
clockwise.
• perpendicular to the perimeter cable (check installation options in the STIGA Stig App).
Procedure:
1. Check the installation requirements as shown in Par. 3.3 .
2. If necessary, prepare the ground so that the surface of the charging base (A) is at the same level
as the lawn (B), the ground must be perfectly flat and compact in order to avoid deformation of the
surface of the charging base.
EN
CAUTION:
Danger of dust in
the eyes.
• Compact soil
• Perimeter cable
• Fixing pegs
• Hammer
• Gloves
GLASSES OBLIGATION:
Use safety glasses to avoid the
danger of dust in the eyes.
A B
3. INSTALLATION
29