Chapter 2
Installation
Optional Installation Procedures
Figure 2-5
Assembling Stacking Clip and Fastener
Push plastic fastener
through small hole
at the end of the
stacking clip.
After assembling the clip and fastener, follow these steps to stack the router with
another device:
Place the clip on top of the lower device, as shown in
Figure
2-6. Slide the clip
Step 1
forward so that the front tabs slide into the vent slots. Make sure that the back
hooks fit over the edge of the lower device.
Cisco 815 Integrated Services Router Hardware Installation Guide
2-11
OL-9558-01