Table of Contents
Advertisement
[start]: start or stop power meter test. The following three methods can achieve this function。
Click this button to start the power meter module to be tested, and the button is changed to
[stop], and then click the button again, then stop the power meter test, and the button content
becomes [start].
[settings]: enter the settings interface, changing the wavelength, unit, the average number of
times, the range of parameters. As shown in figure 4-2.
Fig.4-2 Power meter setting interface
[Wavelength]Wavelength switching can be achieved, selectable wavelengths of 850nm,
Website:
www.baudcom.com.cn
Email:
info@baudcom.cn
Tel: +86-21-37709251
66
Advertisement
Table of Contents
