3.5 Parameter Introduction and Setting Method
Wavelength(nm):Set the OTDR test wavelength.
The setting method:In the parameter settings interface, by clicking [1310nm] or [1550nm]
can choose the corresponding wavelength.
Test range(km):Set scan range.
The range is set according to the actual length of the fiber to select the appropriate
predefined range, it must be greater than the length of the measured fiber, usually set to two
times the length of the measured fiber.
Website:
www.baudcom.com.cn
Email:
info@baudcom.cn
33
Tel: +86-21-37709251