Table of Contents
Advertisement
Cable correction：The placement of the correction factor is the change of fiber length and fiber
length after the fiber optic cable is taken into account. This parameter can be obtained from the
cable manufacturer. The default is set to "1".
The setting method：In the parameter settings interface, click the [optical cable correction],
pop optical cable to modify the input interface, the input optical fiber is the correction factor,
click OK to exit the window.
Event threshold：The event threshold of curve analysis, divided into "splice loss threshold" and
"return loss threshold" and "the end of the optical fiber threshold". Events greater than the event
threshold will be listed in the event table, be ignored which is less than the event threshold.
The setting method：In the parameter settings interface, click on the corresponding
threshold menu to pop up the threshold input interface, click on the input threshold "OK" to exit
window.
Website:
www.baudcom.com.cn
Email:
info@baudcom.cn
40
Tel: +86-21-37709251
Advertisement
Table of Contents
