Table of Contents
Advertisement
●
In the OTDR settings window, set the test item to the connection loss test. At this time
the main operating window will appear in 4 cursors (followed by the cursor a, cursor A, cursor B,
cursor B).
●
Zoom waveform, Position the cursor A in front of the jump edge near the connection
point event, near the location of the connection event.
●
The small cursor before the cursor A is placed at the beginning of the linear segment of
the fiber before the event of the connection.
●
Position the cursor B near the jump edge of the connection point event, near the
location of the connection event.
●
The small cursor at the end of the cursor B is placed at the end of the segment of the
optical fiber before the event of the connection.
●
The connection loss of the measured connection point is displayed on the operation
window.
Website:
www.baudcom.com.cn
Email:
info@baudcom.cn
53
Tel: +86-21-37709251
Advertisement
Table of Contents
