Setting Of Print Format - Detecto DL Series Owner's Manual

PAPER TYPE: Press and hold the Paper Type key for about 3 seconds to switch between gap
paper and plain paper. NOTE: The Paper Type key is only available on the DL1030P/DL1060P.
The DL1030/1060 must change the paper type in Spec021. (0 = Plain Paper, 1 = Gap Paper).
FORMAT: There are 9 kinds of default print formats.
LABEL SIZE: 58mm x 40mm, 40mm x 30mm gap paper, and 58mm and 40mm width plain
paper are available in default print formats. When using a different type of paper, please adjust
the corresponding Spec shown in the table below.
Paper type
58mm x 40mm
gap paper
40mm x 30mm
gap paper
58mm width
plain paper
40mm width
plain paper
A. Print formats include label print and receipt print. If the user needs a custom print format,
use the DLX50 DL Series Scale Utility or contact your service representative. Note that the
DLX50 DL Series Scale Utility can be download at:
https://detecto.com/resources/softwaredetail/dlx50-dl-series-scale-pc-utility
A. Don't print bills while selling: amend Spec003 and Spec008 to 0. If some specific deals
need to print bills, press the Reprint key.
B. To print a few copies of one bill, input the amount into Spec003 and Spec008.
C. To print two different kinds of bills: set the type of bill 1 in Spec000~Spec009, and bill 2 in
Spec010~Spec019. It is recommended users contact their appointed service center.
D. Set Gray Level of gap thermal paper in Spec022.
E. Set Gray Level of plain thermal paper in Spec023.
F. Set the Plain Thermal Paper Cut-Off Position in Spec 025. Note that the position for the
paper cut-off should not be less than 30.
G. You can set different kinds of print formats and barcode types for each PLU. You can check
the details in PLU parameters for print formats and barcode types. Set the value of these
parameters to 0 if you choose the system type.
H. The procedures to confirm print format: take bill 1 as an example. If two or more goods are
sold, print the sum bill and use Spec005 as print format. If only one good is sold, print the
item bill. If sale PLU has been set for a specific print format (not 0), the system would use
the print format. If no specific print format has been set to sale PLU (the setting number is
0.), the print format would be Spec000.

SETTING OF PRINT FORMAT

Print type
Label print
Receipt print
Label print
Receipt print
Label print
Receipt print
Label print
Receipt print
8529-0637-2M Rev C  DL Series Owner's Manual
Spec
000 005 027
1 4 50
7 7 50
2 5 36
8 8 36
1 4 50
7 7 50
2 5 36
8 8 36
0 is the lightest, 9 is the darkest
Instructions
Default
Not recommended
Not recommended
9